The MapsTo3D Blog
How to make maps you can hold: picking an area that works, getting the height right, and printing the thing without fighting your slicer.
-
This summer the freezing level sat above almost all of this print
Swiss glaciers lost 5.5% of their ice in 2026. What the record 4,000 m freezing level and the Aletsch snow line look like on a printed relief model, in millimetres.
-
Nozzle changers and the multicolour map: I counted the swaps
Four-nozzle printers like the Creality K3 and Snapmaker U1 swap colours in five seconds. Measured on a real Matterhorn model: 350 colour changes, and what they cost each way.
-
The purge tower will eat your map
What multicolour costs on a 3D printed map depends on where the colours sit in height, not how many there are. Measured on a real model, layer by layer.
-
The print that fails at hour nine
Why long terrain prints fail late, how the timing tells you whether it is heat creep or wet filament, and the one change that makes the whole problem smaller.
-
AI can make you a mountain. It cannot make you your mountain
Generated meshes are fast, convincing and usually non-manifold. For a real named place they are also guessing. What measured elevation data does differently.
-
3D print your ski resort, for the price of the filament
Breckenridge and Vail sell for $330 on Etsy. The terrain data is public, ski mountains print unusually well, and the resort nobody stocks is the one worth making.
-
How to 3D print any national park, including the one nobody sells
Etsy stocks the famous dozen. The elevation data covers every park on Earth — here is how to frame one so it actually reads.
-
Printing Mount Everest properly
Everest is the first thing everyone makes on a terrain generator, and most results disappoint. The reason is the frame, not the mountain.
-
How to turn any place on Earth into a 3D printable map
A practical guide to going from a flat map to a printed relief model: picking the area, getting the height right, and the slicer settings that matter.
-
The one setting that decides whether your terrain print works
Vertical exaggeration explained with the arithmetic that matters, and honest numbers for mountains, hills and flat ground.
-
3D print your city, with the buildings on it
How to make a city model with real building heights from OpenStreetMap, and how big an area actually works.
-
Turn a GPX track into a 3D printed trail map
Put a hike, ride or race route on the ground it actually crossed, raised so you can feel it.
-
Bigger than your print bed: splitting a map into tiles
Every good map idea is bigger than the printer. How to split one sensibly, and the three things that save grief.
Start with your own town
Search a place, pick a frame, choose what goes on it, and download an STL or 3MF. It runs in your browser and the model never leaves your machine.
Open the map maker





